REVOLABS SOLO™ EXECUTIVE Wireless Microphone System Models: 01-EXESYS, 01-EXESYS4, 03-EXESYSEU and 03-EXESYSEU4 Installation and Ope
- 7 - Using the Revolabs Solo™ Executive Base Station The Revolabs Solo™ Executive Base Station, shown below in front and rear panel views, manages
- 8 - Installing the Solo Executive Base Station The Revolabs Solo™ Executive Base Station is designed to be installed into a standard 19” AV rack sy
- 9 - There are four or eight output channels representing a separate channel for each microphone. Accordingly, there are four or eight input channel
- 10 - 3. Press the Mute button on the Charger Base once. The LEARN LED on the back of the Base Station panel will go off and the power LED on the C
- 11 - Using the Rear Panel DB25 Control Port The DB25 Control Port allows the use of third party control and muting systems, using parallel port IO
- 12 - Using the Rear Panel BUS Connector for Multiple Systems If more than one Revolabs Solo™ Executive Base Station is used in an area, each unit n
- 13 - • Solo Tabletop Wireless Boundary Microphone. • Solo Universal Wireless Adapter for Handheld Microphones. Using Revolabs Solo™ Wearable Wire
- 14 - 3. With the microphone in the wearing position, un-mute the microphone by pressing and releasing the Mute button (confirm by viewing flashing
- 15 - 1. Mute button — press to mute, un-mute and pair microphone. 2. LED display — visual status for mute, un-mute, and pairing. 3. Integral grill
- 16 - Using the Solo XLR Microphone Wireless Adapter The Revolabs Solo™ Universal Wireless Adapter for Handheld Microphones, shown in the following
© 2007 REVOLABS, INC. All rights reserved. No part of this document may be reproduced in any form or by any means without express writt
- 17 - The Adapter does not provide phantom power or bias current so it cannot be used with condenser or electret microphones. 2. With the microph
- 18 - In normal use, batteries should fully charge in about 2 hours, and can be “quick-charged” to 80% capacity in 45 minutes. The batteries of micr
- 19 - quick GREEN flash, then switching to flashing RED on both the microphone and the Base Station (muted audio). Pairing is now complete.
- 20 - Revolabs Solo™ Executive Indicator LEDs The following tables show activities associated with the various states shown by the LEDs: Equipment
- 21 - Warranty Revolabs, Inc. warrants this product to be free of manufacturing defects. Repair or replacement of any defective part or unit (at the
- 22 - Specifications Dimensions, (L, W, H) and Weight: Executive Base Station 16.9” (43.03 cm) x 8.0” (20.32 cm) x 1.7” (4.42 cm), 6.5 lbs (2.95 kg
- 23 - Appendix A – Adjusting Base Station Power Level Important: Adjusting RF power settings as described below should only be performed by trained
- 24 - 3. Release the button after the channel LED flashes green twice for reduced power level 2. Release the button after the channel LED flashes
- 25 - Appendix B – Synchronized System Channel Settings Note: Adjusting channel settings as described below should only be performed by trained and
- 26 - 3. Release the button after the channel LED flashes GREEN twice for synchronized Mode A. Release the button after the channel LED flashes gre
- iii - Contents Safety and General Information ...
- 27 -
- 28 - Index . Mini-Phoenix Connectors, 6 . On/Off Switch, 6 Adjusting Base Station Power Level, 20 Adjusting the Volume, 12 Associate LED, 8 Associa
R e v o l a b s S o l o ™ E x e c u t i v e M a n u a l 0 1 - E X E M A N - P A P
Safety and General Information Please read the following information to ensure safe and efficient use of your Revolabs system. FCC User Informat
- 2 - Other Medical Devices If you use any other personal medical device, consult the manufacturer of your device to determine if it is adequately sh
- 3 - WEEE Notification: The Waste Electrical and Electronic Equipment (WEEE) directive (2002/96/EC) is intended to promote recycling of electrical a
- 4 - Introduction Congratulations on your purchase of a Revolabs digital wireless microphone system! This system utilizes 1.9 GHz DECT technology, a
- 5 - antennas and offers individual line-level audio in/out for each microphone channel. This allows for additional post processing such as: • Acou
- 6 - Using the Revolabs Solo™ Executive Charger Base When Microphones are not in use, they should be properly inserted into the Solo Executive Cha
Commentaires sur ces manuels