Revolabs 85 Manuel d'utilisateur télécharger pdf

Revolabs Fusion™ Wireless Microphone System- Tandberg Edge 75/85/95

MXP Setup Guide

NOTES AND CAUTIONS:

This setup guide will guide you through the steps needed to properly connect a

Revolabs Fusion System to a Tandberg Edge 75/85/95 MXP video codec.

1. Connecting the Cables

2. Configuring the Edge MXP Video Codec

Note:

It is important to carefully follow these instructions in order and completely.

Otherwise your Fusion System and/or the video codec may not function properly.

Please read through these instructions completely before proceeding. Contact Revolabs

technical support if you have any questions.

Requirements for connecting systems:

1. Revolabs Fusion 4 or 8 microphone system

2. Tandberg Edge 75/85/95 MXP video codec

3. QTY 1 XLR male to XLR male cable

4. Qty 2 RCA-RCA male cable

5. Amplified speakers

NOTE: IMAGES OF SET UP SCREENS ARE DEFAULT SETTINGS FROM TANDBERG AND ARE PART OF THE

TANDBERG MXP ADMINISTRATOR’S GUIDE © MAY 2008

1 2 3 4

Revolabs Fusion™ Wireless Microphone System- Tandberg Edge 75/85/95 MXP Setup Guide NOTES AND CAUTIONS: This setup guide will guide you through the

Page 2

Connecting the Cables CONNECTING A REVOLABS FUSION TO TANDBERG EDGE 75/85/95 MXP VIDEO CODEC 1. Connect a Male RCA-RCA audio cable between the “Co

Page 3

Configuring the Edge 75/85/95 MXP Video Codec CONFIGURING THE AUDIO MENUS OF THE EDGE MXP VIDEO CODEC 1. Go to AUDIO SETTINGS 2. Select INPUTS 3

Page 4

6. Return to previous menu and select OUTPUTS 7. Confirm that Out1 is ON 8. Adjust the audio Output Type Level if necessary (recommend +0dB)

Pas de commentaire

Revolabs 85 Manuel d'utilisateur