Revolabs HD Single & Dual Channel System — Polycom VSX Manuel d'utilisateur télécharger pdf

Revolabs HD Single / Dual Channel System — Polycom VSX 8000 Setup Guide

This setup guide will guide you through the steps needed to properly connect a

Revolabs HD Single or Dual Channel System to a Polycom VSX 8000 video codec.

Note:

It is important to carefully follow these instructions in order and completely.

Otherwise your Revolabs Microphone System and/or the video codec may not function

properly. Please read through these instructions completely before proceeding.

Contact Revolabs technical support if you have any questions.

Requirements for connecting systems:

1. Revolabs HD Single or Dual Channel System

2. Polycom VSX 8000 video codec

3. QTY 1 3.5mm balanced male connector to 3-pin mini Phoenix connector

cable*

* 07-35MBTOMPHX-01 6’ 3.5mm balanced male connector to 3-pin mini

Phoenix connector cable available from Revolabs

3.5MM STEREO MALE TO PHOENIX CONNECTOR CABLE DIAGRAM

Revolabs either recommends using the Revolabs 07-35MBTOMPHX-01 6’ 3.5mm balanced

male connector to 3-pin mini Phoenix connector cable, or cutting the end off an 1/8” cable and

attaching the green Phoenix connector as shown above.

1 2

Page 1

Revolabs HD Single / Dual Channel System — Polycom VSX 8000 Setup Guide This setup guide will guide you through the steps needed to properly connect

Page 2

Connecting the Cables 1. Insert the balanced 3.5mm male connector to the CH 1 OUT port on the Single or Dual Channel System. If using a Single Chann

Plus de documents pour Équipement Revolabs HD Single & Dual Channel System — Polycom VSX

Pas de commentaire