Revolabs Single Channel System - Polycom VSX8000e Manuel d'utilisateur télécharger pdf

Revolabs Single Channel System - Polycom VSX8000e Setup Guide

NOTES A ND CA UTIONS:

This setup guide will guide you through the steps needed to properly connect a

Revolabs Single Channel System to a Polycom VSX8000e video codec.

1. Connecting the Cables

2. Configuring the VSX8000e Video Codec

Note:

It is important to carefully follow these instructions in order and completely.

Otherwise your Single Channel System and/or the video codec may not function

properly. Please read through these instructions completely before proceeding.

Contact Revolabs technical support if you have any questions.

Requirements for connecting systems:

1. Revolabs Single Channel System

2. Revolabs 2.5mm to RCA Audio Cable (included with Single Channel)

3. Polycom VSX8000e video codec

*POLYCOM VSX 8000 SERIES VIDEO CODECS HAVE PHOENIX CONNECTORS FOR LINE INPUT WHILE THE REVOLABS

SINGLE CHANNEL SYSTEM USES RCA CONNECTORS FOR AUDIO INPUT/OUTPUT. A TECHNICIAN COULD SIMPLY CUT

OFF THE ENDS OF THE 2.5MM TO RCA AUDIO CABLE AND CONNECT PER THIS DIAGRAM (REFERENCED FROM THE

POLYCOM INTEGRATOR’S REFERENCE MANUAL FOR THE VSX SERIES VERSION 8.7, AUGUST 2007):

1 2

Revolabs Single Channel System - Polycom VSX8000e Setup Guide NOTES A ND CA UTIONS: This setup guide will guide you through the steps needed to prop

Page 2

Connecting the Cables CONNECTING A REVOLABS SINGLE CHANNEL SYSTEM TO POLYCOM VSX8000E VIDEO CODEC 1. Connect a Revolabs 2.5mm to RCA audio cable b

Pas de commentaire

Revolabs Single Channel System - Polycom VSX8000e Manuel d'utilisateur