Revolabs FLX2 Manuel d'utilisateur télécharger pdf (Page 37)

Pairing

All FLX2 wireless components are paired before the system is shipped, providing much

of the system setup already completed. While pairing should not be required for the

system to work, sometimes components can require pairing if a part is shipped

separately. The following aree instructions on how to pair the wireless components of

the system to the FLX2 Conference Phone.

To pair the FLX Dialer, follow this procedure. Please note that Microphones and

Speakers require a Dialer to be paired with the Base Station before you can pair them.

Dialer

1. If the Dialer is turned on, turn it off by pressing and holding the red ‘end call’

button until an overlay appears asking whether you want to shut the Dialer down.

Press ‘Yes’.

2. Plug in the FLX2 Base Station.

3. Turn the Dialer back on (press the red ‘end call’ key). The screen should read

“Scanning for new base”. If the screen reads “scanning for paired base”, press

the ‘Stop’ button, press the ‘Menu’, and select ‘Re-Pair’. When asked whether to

‘Scan for New Base’, select ‘Yes’.

4. After some time scanning for available bases, an overlay will appear asking ‘Pair

with <System Name>?’ Select ‘Yes’.

5. An overlay, ’Pairing with base <System Name>’, should appear followed by a

‘Connecting…’ and then and ‘Initializing…’ screen. Shortly after that the Dialer

home screen will appear. Your Dialer is now paired.

6. If the Dialer does not automatically pair, repeat steps 1-5. If this still does not

resolve the problem, select “Reset Factory Defaults” as this will force a scan for a

new base.

Speaker

1. To pair a Speaker, if the Speaker is turned on, turn it off

by pressing and holding the button on the bottom of the

Speaker until you hear the Speaker shut-off or the

LEDs turn off.

2. Ensure that the Base Station is plugged in and powered

up.

3. On the Dialer, browse to the Pairing menu: Menu 

Setup  Advanced Setup  Pairing.

4. Select SPK 1 (Speaker 1) and press the ‘Enter’ or ‘Pair’

key to enter pairing state.

5. The screen will display ‘Pairing Speaker 1’.

6. Press and hold the button on the bottom of the Speaker

until the LED turns solid red.

7. An overlay will appear on the Dialer “Pairing

Successful”, after that the screen should read ‘SPK 1

Linked’.

8. If pairing was unsuccessful, the Speaker will show an

alternating red -green slow blinking sequence indicating

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 50 51

Commentaires sur ces manuels

Pas de commentaire

Revolabs FLX2 Manuel d'utilisateur Page 37

Commentaires sur ces manuels

Produits connexes et manuels pour Smartphones Revolabs FLX2