Revolabs FLX2 Manuel d'utilisateur télécharger pdf (Page 7)

Quick setup for Telephone Conference Calls

While all components delivered with the Revolabs FLX2 Conference Phone are partially

charged, we recommend charging the Speaker, the Microphones, and the Dialer for at

least 8 hours or overnight before starting to use the system.

Please note that the Revolabs FLX2 Conference Phone comes with two different power

supplies. Please ensure that you are using the correct power supply when connecting

the Base Station and the Charger Base.

Connecting the Base Station

Place the Base Station close to the analog

telephone outlet you want to use for the

conference phone. Connect the Base Station

to the telephone network using the provided RJ

11 Telephone cable. Use the 5 Volt power

supply to connect the Base Station to mains

power.

The Base Station will power up.

Connecting the Charger Base

Place the Charger Base at a location where

you can easily access the Microphones and

the Speaker for your conference calls, e.g. on

a side board, a desk, or the conference table.

Connect the Charger Base to the mains power

using the provided 12-15V power supply.

Place the Speaker, the Microphones, and the

Dialer in the respective openings of the

Charger Base to charge them.

The Microphones, Dialer and Speaker will

automatically connect to the Base Station after

a short time if it is powered up. You will hear a

confirmation chime from the Speaker once the

system is ready for use. If any of the

Microphones, the Speaker, or the Dialer is not

powered up, take them out of the Charger

Base for a few seconds and put

them back in. This will switch on

each of the components.

1 2 3 4 5 6 7 8 9 10 11 12 ... 50 51

Pas de commentaire

Revolabs FLX2 Manuel d'utilisateur Page 7